P0700Wysoki
System sterowania skrzynią biegów — usterka
Układ napędowy
Sprawdź szczegóły →P2835
WysokiIntermittent Signal in Gear Shift Fork Position Circuit 'A'. The code indicates an electrical discontinuity in the monitoring system for the position of the gear selector fork 'A' in the transmission.
OBD-II (EN): Shift Fork Position Sensor A Circuit Intermittent
Code P2835 indicates an intermittent fault in the electrical circuit of the gear shift fork position sensor 'A' in the transmission. The problem can be caused by a faulty sensor, damaged wiring, corroded connectors, or a TCM module fault. Due to the risk of the transmission entering limp mode and potential driving safety hazards, prompt diagnosis at an authorized service center is recommended.
Symptoms
Incorrect or delayed gear shifts Transmission slipping during gear changes Transmission enters limp mode Flashing Check Engine Light Jerking or thudding during gear changes Possible loss of selected gear Problems maintaining the correct gear ratio
Possible causes
Damaged or worn gear shift fork position sensor 'A' Incorrect wiring or damaged electrical connectors in the sensor circuit Corrosion or loose electrical connectors on the transmission control module (TCM) Faulty transmission control module (TCM) Mechanical damage to the shift fork or selector mechanism Contaminated or low transmission fluid level Electromagnetic interference causing intermittent signals
Affected systems
Skrzynia biegów (automatyczna/dwusprzęgłowa)Moduł sterowania skrzynią biegów (TCM)Układ elektryczny/okablowanie skrzyni biegówMechanizm zmiany biegów
Related codes
P0750Wysoki
Elektrozawór zmiany biegu A — usterka obwodu
Układ napędowy
Sprawdź szczegóły →Sources and further reading
Does code P2835 require professional diagnostics?
The code alone is not enough. To find the cause, you need to read live data, check freeze frame conditions, and compare with vehicle behavior. Book a diagnostic session.